Clik here to view.
DevEUI for non-hardware assigned values
BoRRoZ: but you cannot buy just 10 chips http://www.microchipdirect.com/ProductSearch.aspx?keywords=24AA02E64Starting at €0.19 for onesies, excluding the postage Cheers,
View ArticleHaarlem, The Netherlands
Note that my tests were not dedicated tests; I just took a node up into the tower when Gerard showed us around. I've been standing still at a few locations for a few minutes each time, to get at least...
View ArticleDevEUI for non-hardware assigned values
You'll have to judge whether you want to use a random ID. However, the definition of EUI-64 allows for this. The definition is given in chapter 8 of the IEEE-802 spec (freely available at...
View ArticleIs there a wiki page for setting up a private backend
Hi @ndarkness, I am at the very beginning right now. I will give it a go today and write down my steps including descriptions to docker compose installation. I will share the link. I am hoping to do...
View ArticleClik here to view.
TTN Cookbook - call for feedback
gonzalocasas: Instead of that, would it be possible to already launch allowing also community recipes at least in the "linked to external site" mode at the beginning? What recipes do we expect to be...
View ArticleClik here to view.
TTN Cookbook - call for feedback
Batilan: What recipes do we expect to be community specific? I don't mean community specific, only created/produced by the community.
View ArticleIs there a wiki page for setting up a private backend
Hi @darkness,I went trough all your posts and used the ones relevant to me. I did not come across many of your problems though. I should say I did not connect a node and a gateway yet so I cannot talk...
View ArticleTTN in Erfurt, Germany
Hey! I would like to find people near Erfurt to build a The Things Network in the center of Germany and i would like to setup the network in the context of my local hackerspace bytespeicher....
View ArticleClik here to view.
Is there a wiki page for setting up a private backend
Nice walk-through, @Daghan! It would be really nice if you could add this to the wiki page about Docker-based deployment. Just fork the wiki and submit a pull request with your changes Daghan: yaml...
View ArticleDevEUI for non-hardware assigned values
I think we have our solution. Thanks, @terrillmoore!
View ArticlePerformance of TTN gateway in NLOS condition
I did express similar concerns back in February. In a few posts I have also tried to raise interest in connecting to the world of home automation in a few threads here, since I expect that such...
View ArticlePerformance of TTN gateway in NLOS condition
Hi all, I've tested a Kerling using a very small Node with a minimal antenna and I've got signal from 1.5 Km in NLOS. Anyway as radio amateur with a bit of experience in antenna and radio...
View ArticlePerformance of TTN gateway in NLOS condition
Antenna gain works both ways as far as I know. So +3 dB gain on the gateway side works for both Tx and Rx. The real limiting factor imho shall be the node output power, due to battery limitations....
View ArticlePerformance of TTN gateway in NLOS condition
Yes sure, the antenna works in the same way bidirectionally. But bidirectional transmission is done in different ways:- when the node receive the transmitter antenna is big and efficient. - when the...
View ArticlePerformance of TTN gateway in NLOS condition
Assuming the node has a gain of 1 and the gateway has a gain of 4 dB, your total gain on both Rx an Tx is 5 dB. The poor Tx is compensated by the Rx gain in the uplink. The big Tx gain in the downlink...
View ArticleClik here to view.
[HowTo ]Regain root access on Kerlink
Hi all, With response to my own tread (http://forum.thethingsnetwork.org/t/kerlink-installation-not-possible-wiki-possibly-out-of-date/2065), I have managed to regain root-access to a Kerlink. The...
View ArticleKerlink installation not possible (wiki possibly out-of-date)
I managed to regain root access: http://forum.thethingsnetwork.org/t/regain-root-access-on-kerlink/2140
View ArticlePerformance of TTN gateway in NLOS condition
That's the theory and in this sense so you are right. But antennas are more complex devices. If the real wold works as the simplified theory says you should be able to compensate a small antenna with...
View ArticleArduino UNO + RN2483 needs power interrupt to start
@Martijn78 Have you gotten it to work ? @kersing thank you. What about the LED on the RN2483 Bee, do you happen to know how to make use of it ?
View ArticleClik here to view.
Arduino UNO + RN2483 needs power interrupt to start
grease: What about the LED on the RN2483 Bee, sys set pindig GPIO0 1 to switch it on and sys set pindig GPIO0 0 to switch if off To wake it from sleep I use ; void wakeUP_RN2483() { Serial1.end();...
View Article