I'll start with some really obvious questions
Open a terminal session using an application such as TeraTerm with baud rate 115,200
Issue these commands with the same values you set for the Conduit:
AT+FSB=value (915 NA only | value = frequencySubBand from your Conduit) <--- not applicable in Europe
AT+NI=1,value (value = Network Name for your Conduit) <---- Which value is this?
AT+NK=1,value (value = Network Passphrase for your Conduit) <---- I'm assuming the standard reference code in the Wiki
AT&W (save settings)
ATZ (restart)
Join the network: AT+JOIN
Send data with ACK requested:
AT+ACK=1
AT+SEND=hello world
Sorry if this is newbie, beginner stuff, but that is exactly where I am in all this.