The gateway is supplied and communicates through a standard 10/100T Ethernet cable. The PoE power injector is supplied with the gateway. The antenna must be connected through a low loss N type coaxial cable. We recommend a 3 to 8dBi vertically polarized antenna. The gateway integrated RF filters are sufficient to reject all cellular out of bands interferers even from nearby base stations. The gateway can safely be installed out-door and is IP65 water proof.
The gateway power supply is provided through the Ethernet data cable. The gateway is supplied with an adequate PoE injector. Connect the “Data” port of the PoE injector to your Ethernet router, and connect the “Data + power” port to the gateway. The gateway must have access to the internet through the Ethernet router else the packet will not be forwarded to Semtech’s network server.
Once this is done plug the PoE injector to the 220V main. The gateway boots up.
The above procedure was described in the installation manual. i followed all the steps but wen i plugged in the poe injector the gateway didnt boot up/...How will i know whether the gateway(kerlink) is booting up or turning on. Some LEDS will indicate that or what??.. Thanks in advance