Hot pictures: SODAQ LoRaONE
Hi Gary, The Microchip RN2483 module actually allows for 433 as wel as 868 Mhz. We are currently implementing a change in the design that allows us to wire the LoRaONE up to the 433 MHz antenna output...
View ArticleRN2483 Breakout?
Hi @gozkilYes I have some available, where are you based? thanks Andrew
View ArticleClik here to view.
Connecting iC880A-SPI concentrator to Raspberry Pi 2 Type B
champ8242: failed to start the concentrator If you're getting that error, chances are there's either a problem with the wiring or -as @ernestopace said- you need to enable SPI using raspi-config.
View ArticleWhere to find the RF packet definition in Protocol.txt?
I try to simulate the gateway behaviour to server, the reference document is protoco.txt. i am able to PUSH_DATA and get ACK from server. In the json string, it mentions a data section for RF packets....
View ArticleWhere to find the RF packet definition in Protocol.txt?
The raw packet can be found base64 encoded in the json object (data: ....) The description can be found in the lorawan specification here...
View ArticleNode with ESP8266 and RFM95W
Hi Maarten, So if I read your diagram correctly should it be connected like this?(DIO3 and GPIO3 should not be connected right?) Connect:DIO1 <--> GPIO4DIO0 <--> GPIO5MISO <-->...
View ArticleClik here to view.
Smallest expected node
projextX140.jpg960x691 109 KB you can use the 'big' china infrared motion sensors (PIR) at 3 V (0.032 mA rest and 0.071 mA motion)see -...
View ArticleClik here to view.
Connecting iC880A-SPI concentrator to Raspberry Pi 2 Type B
Thanx for your support gentleman! it was the cabling. Counting is hard Cheers!
View ArticleHot pictures: SODAQ LoRaONE
If you order now: http://shop.sodaq.com/en/sodaq-loraone-beta.html?id=41855446&quantity=1 we will ship it on the 15th of March!
View ArticleWhich Node to buy
Hello Eric, I assume you downloaded the project from the RN2483 product page. From memory I had a similar problem where it didn't build (it was a fresh install of the IDE too). Can't remember all the...
View ArticleLoPy: micro-python LoRaWAN nano gateway board with WiFi/BLE
The LoPy Kickstarter campaign will launch tomorrow. Basically this board can be configured as a Node or as a "nano" Gateway supporting up to 100 Nodes itself. Runs micro-python, combines LoRa with...
View ArticleNew Gateway Registration
Hi all, Is this problem with the coordinates, description and owner info already solved? I put them for the Lorank8 in de global json but a API / Json request show's no change....
View ArticleNew Gateway Registration
per instructions these should go in local_conf.json - do not forget to reload - systemctl restart lorank.service
View ArticleRoadmap architecture
Hi guys, We would love to run our own handlers etc. but it seems there is no software yet. Is there a roadmap for the architecture with release dates?
View ArticleParse data
Hi, I'm trying to parse the rawData coming over MQTT as well in order to add my own application encryption. Thanks to topic I can find a lot of answers, but I do not succeed in decoding the Payload...
View Article