Clik here to view.
Proper setup?
I can see them http://thethingsnetwork.org/api/v0/nodes/02033A01/ Thank you very much!
View ArticleClik here to view.
Proper setup?
One question: where could I have found this information (about the keys)?And why are the appSkey and nwkSkey the same? Two questions I see
View ArticleProper setup?
Please read http://thethingsnetwork.org/wiki/Hardware/OverviewNodes#general-settings-instructions it should answer your questions.
View ArticleClik here to view.
MTAC-LORA-868 & Raspberry PI downlink
The instructions use the basic_pkt_fwd == basic packet forwarder. This forwarder allows sending to one destination. You need to compile poly_pkt_fwd and use it to allow for multiple destinations. (At...
View ArticleClik here to view.
Smallest expected node
Thx, but it looks like that one is for the mbili., not the autonomo?Anyway it's a good starting point, i want to modify it so it can also fit a solar panel.
View ArticleSmallest expected node
No, this one is for the Sodaq Autonome http://www.thingiverse.com/thing:1297883
View ArticleAustralia: Melbourne and beyond
what bands are used in Australia? I would be interested to help also from Brisbane, but make sure im using correct bands not something licenced to a Telco. CheersPeter
View ArticleRaspberry Pi LoRaWAN Gateway Board
is something known about the capacity (band/nodes) ? Example from the wiki: Capacity: 8 band, ~ 20K Nodes
View ArticleClik here to view.
Hot pictures: SODAQ LoRaONE
Looks like an interesting board Please can you tell me:a) how much does it weigh?b) can I turn GPS on and offc) do you have any figures on power consumption? Thanks, Mark
View ArticleHopeRF95W stuck in OP_TXRXPEND
Hi, I've got a Teensy 3.2 and HopeRF95W plus a GPS sensor. I've been using the example code from the wiki and can successfully send one message, but after that the sketch reports that the radio is...
View ArticleHopeRF95W stuck in OP_TXRXPEND
Is it waiting for an ACK which never comes?(I'm guessing from RX PENDing ??)
View ArticleHopeRF95W stuck in OP_TXRXPEND
Maybe one of the dio lines is not well connected? The CPU keeps waiting for the transmission then.
View ArticleHot pictures: SODAQ LoRaONE
I'd be interested in knowing what the sleep power figures are too. Got a battery based project so looking for comparable results to the Multitech mDot modules. thanks Andrew
View ArticleClik here to view.
IoT Animal challenge - needs your sparkling minds
The League Against Cruel Sports and IFAW have just launched the IoT Animal challenge:https://www.connecttvt.co.uk/iotanimal/ I created this topic/use case in the hope that TTN might form a team or...
View ArticleRaspberry Pi LoRaWAN Gateway Board
It is the same basic design as the Kerlink or Multitech gateway, so capacity would be "the same." The number of nodes is entirely dependent on their duty cycle, and the number of downlink messages.
View Article