Setup a LoRa Mote (RN2483) for TTN

Hi all,

We have two LoRa Motes we'd like to connect to TTN in Amsterdam. We are in range of the Deloitte gateway.

After setting the configuration parameters, we expect to type a send command like mac tx uncnf 1 AABBCC and see that message in the nodes API page, but we see other nodes' messages, not ours. Did we miss something?

As device address we've chosen 03:FF:81:23 which should be in the test range. Is that OK? Is there any filtering based on the addresses?

Below this post you'll find the list of commands we entered to the RN2483 modules to configure the node. Is that correct for TTN?

Thanks!
Enrico

sys factoryRESET
.RN2483 1.0.0 Oct 23 2015 14:48:20
sys get hweui
0004A30B001ADED4
mac set appskey 2B7E151628AED2A6ABF7158809CF4F3C
ok
mac set nwkskey 2B7E151628AED2A6ABF7158809CF4F3C
ok
mac set ch dcycle 0 9
ok
mac set ch dcycle 1 9
ok
mac set ch dcycle 2 9
ok
mac set adr off
ok
mac set devaddr 03ff8123
ok
mac save
ok
mac join abp
ok
accepted
mac set dr 0
ok
mac save
ok

mac tx uncnf 1 AABBCC
ok
mac_tx_ok